re.ality

no matter where you go, there you are

Skip to content
  • Home
  • Food & Drink
    • Our Pizza Oven
    • Coffee
    • Recipes
  • Hobbies
    • Aquarium
    • 3D Printing
    • Home Automation
    • Jeep
    • Woodworking
  • Misc.

Timelapse Gecko Printjob

November 8, 20173D Printingadmin

Repositioned the camera, but will need to make a new piece to get the camera rotated into landscape mode again.  This works much nicer for the timelapse, and can see the object rising from the print bed.  This clip is taking a shot every 10 seconds throughout the print (I think that was the default setting in OctoPrint).

https://www.ality.org/wp-content/uploads/2017/11/modified_axial_layer_shroud_v3_timelapse.mp4

Post navigation

← My Gecko Handy Tools! →

Recent Posts

  • Upgrade for coffee nirvana!
  • Pour-overs again :)
  • Canelés – they really aren’t that difficult – you just have to wait :)
  • Chef’s Plate experience
  • Secure your home network

Recent Comments

  • ray on Pour-over coffee gear
  • Thanksgiving 2014 | re.ality on Orange Honey Glaze
  • Thanksgiving 2014 | re.ality on Crockpot Maple Roasted Vegetables
  • ray on Murphy strikes the Jeep – again!
  • ray on New additions to the aquarium

Archives

Categories

  • 3D Printing
  • Aquarium
  • Coffee
  • Food
  • Hobbies
  • Home Automation
  • Jeep
  • Misc.
  • Music
  • Recipes
  • Woodworking

Meta

  • Log in
  • Entries feed
  • Comments feed
  • WordPress.org
Proudly powered by WordPress